This project was cut on the Eclipse scrollsaw. The first project made with
this saw that I purchased at the Pontiac Picnic 2002.
|
The work area I use for marquetry. I have all the needed
supplies right here on handy. |
|
This is the project all cut and taped from the back with
masking tape. I used the regular painter tape with no problems on this
project. If the wood grain was more brittle I would have used the blue
painter tape. |
|
This is the front side with the perforated veneer tape in
place. The tape is applied one piece at a time, then the brush is used to
work it into the wood. This layer of tape stays on during the gluing
process. After the project has been glued to the backing this face will be
sanded to remove the tape. With this tape in place, the masking tape
on the back side can be removed. |
|
Part of the scrap generated in the cutting process. |
|
Parts in the vacuum press |
|
The vacuum press |
|
Finished project |